Mercedes-Benz GL / GLS 3D-printable parts

Dashboard phone-mount adapter designed by the creator for the GL 450 X164 and shown physically installed between the two center vents. The supplied single STL has a 17 mm ball for a compatible phone cradle. The source does not state model year, pre- or post-facelift fitment, market, steering side, dashboard option, attachment method, material, print settings, device weight, or retention testing. Compare the center-vent surround before printing, use a cabin-heat-resistant material, protect the original trim, keep the mount clear of vents, controls and sight lines, and verify that the adapter and cradle remain secure under braking before road use. Do not place a device where it could interfere with an airbag.

Two-piece repair for the right-hand locking pin/holder used when the retractable luggage-compartment cover is pulled across the cargo area. The creator designed it from the broken component on a 2006 vehicle and separated the base and holder because a one-piece print was too tight to install; clip in the base, then bond the holder to it. Mercedes EPC-style evidence identifies exact child A1648120201 as the right cargo-cover locking pin and maps that same component to W164 and X164. Verify side, colour/trim interface and retention before use.